Automotive

Menu Show

Tel: 0086 755 23248547
Fax: 0086 755 23248547
Skype:simon9969@hotmail.com
Linkman:Simon Gao
Postcode：518106
Web: www. injection-flow.com
E-mail:simon@mpa-tooling.com
Address: Building Yonghui, No. 202, Changchun north Road, Guangming new district, Shenzhen city, China

Automotive

Plastics Analysis Solutions for Automotive Applications

MPA have analyzed thousands of automotive mouldings over the years including The area of automotive including Lighting, Rear-view cover, interior shell, instrument panel, cooling system, AC system, chair system, tank, engine cover, etc.
Automotive production techniques are often at the forefront of technological development and MPA has been active in aiding the development of many advanced systems.

Bumper systems

Polypropylene bumper systems are a good case in point, over the last 10 to 15 years moving from painted . multi feed tools to large film gates and now sequential feed hot runner systems .

Interior Panels

The use of sequential injection has also seen a reduction in the requirement to paint

and now the addition of complex integral detail such as speaker grilles and air bag doors is

common place. Some interior panels now incorporate thick feel gas injected door pockets

and thin speaker grille sections eliminating the need for several mouldings.

Under Body Mouldings

Large Under Body mouldings are normally produced as thin as possible, resulting in high pressure and clamp force. Sophisticated feed systems and smart wall thickness profiles are used to reduce pressure and clamp force to achieve the most economical production.